PadlockPay securely withVisaMastercard

FJ Cruiser

For all your steering and suspension parts for your Toyota , from bushes , springs , shock absorbers ( Bilstein Koni Raw Sachs Kyb Formula ) , lift kits , airbags , Ball joints and Coil Over Kits

Items 1 to 12 of 24 total

per page
Page:
  1. 1
  2. 2

Set Descending Direction
  • Toyota Hilux KUN26r 4wd Diff Drop Kit

    When lifting IFS Vehicles, the Constant Velocity (CV) joints are put on an increased angle. This increased angle of the CV joint during operation can accelerate
    the wear on the joint, as well as putting additional stress on the CV boots leading to splitting and eventually premature failure of the CV. This wear is accelerated
    further if larger (wider) wheels and tyres are fitted.
    The Roadsafe IFS Diff Drop Kits are application specific and supplied complete to get the job done. The bolt on kit corrects the geometry on the front driveshaft
    and CV’s, lowering the front diff by approx. 25mm, thus reducing the angles the CV joints need to operate on, and avoiding the expensive replacements of CV’s
    and boots. Allows the bash plate to be refitted.
    Toyota Hilux KUN26r 4wd Diff Drop Kit
    $135.00
  • TOYOTA FJ CRUISER RAISED REAR BILSTEIN SHOCK ABSORBER

    TOYOTA FJ CRUISER RAISED REAR BILSTEIN SHOCK ABSORBER

    Performance you can feel. If you expect more damping power from your shock absorber – even under loads – but don’t want to opt for an all-out race solution, the BILSTEIN B6 Sport is ideal.

    The product benefits at a glance:

    Increased power reserves and service life, even when pulling transporters and trailers or during frequent journeys with loads
    Optimum adhesion and enhanced lane change stability in both day-to-day and extreme situations
    Marked improvement in safety and performance without additional spring changes (standard springs can be used)
    BILSTEIN gas pressure technology
    BILSTEIN mono-tube/Upside-Down technology, made in Germany
    Road and track tested by BILSTEIN for fine tuning
    46mm piston, a winning formula with over 50 years of development
    TOYOTA FJ CRUISER RAISED REAR BILSTEIN SHOCK ABSORBER
    $440.00
  • Toyota FJ Cruiser 2010 on Raised Rear Polyair Airbag Kit



    Polyair Red Series bags are designed to fit inside the coil of a coil sprung vehicle to assist the spring in supporting whatever load is placed in the vehicle (within manufacturers recommended gross vehicle weight rating). They help in eliminating “bottoming out” and improve ride, handling and stability. The air adjustability allows you to tune the ride you want, whether you’re hauling, towing or riding light! Made with tough, long-lasting, moulded polyurethane.

    Features and benefits of the Polyair Red Series

    Add support to rear springs on many vehicles.
    Improves muscle car traction for drag racing.
    Improves ride and handling for full-size vans with front coils.
    Fits open coil springs, front or rear.
    Up to 450kg (1,000 lbs) of levelling capacity.*
    Air adjustable for the ride you want.
    Reduces roll, sway and “bottoming out.”
    Quick connecting easy-to-use engineered polymer air fittings.
    Tough moulded polyurethane construction.
    One year 20,000km limited warranty.
    Toyota FJ Cruiser 2010 on Raised Rear Polyair Airbag Kit
    $295.00
  • HEAVY DUTY ROADSAFE TOYOTA FJ CRUISER RECOVERY TOW POINTS

    Tow Points have been designed as matched pairs, supplied in LH/RH for vehicle specific fitment. Your purchase will include high tensile bolts, and any additional, vehicle specific mounting hardware required to ensure secure fitment to vehicles. Correct fitment of these components is critical for yours & others personal safety.

    Each pair of Tow Points is supplied with vehicle specific fitment instructions. These instructions should be followed during fitment to ensure all steps are taken for correct installation, so when required, the points will be at their optimum Working Load Limit (WLL) as stamped. It is the Tow Points themselves as supplied that have been tested to the WLL advised. It is at the vehicle owners discretion for fitment, ensuring that the chassis is adequately designed, constructed and/or rated to suit this application.

    It is recommended that Tow Points are fitted by a qualified mechanic with specialist 4WD knowledge, who has an understanding of your vehicle including weights carried, the style of Bull Bar, general usage etc. as in some circumstances these Tow Points may not be suit- able for your vehicle.

    These Tow Points have not been tested for lifting purposes & should not be used for lifting, the forces applied differ between lifting and straight line pull type recoveries.

    If a recovery is to be performed, it is imperative both recovery points are utilized, ideally with the use of a bridle strap. This will share the load through the front of your vehicle, giving increased strength and safety margins, the use of a bridle strap will also keep all com- ponents tethered in the case of a failure, reducing the risk of serious injury or death.

    Always INSPECT the Tow Points and shackles before each use. Do not use if there are visible signs of damage or wear (including cracking or elongation). Do not exceed the Working Load Limit (WLL) of the shackle or Tow Points. Always STAY A SAFE DISTANCE away from the recovery area – at least 1.5 times the length of the recovery strap. Incorrect use of recovery equipment can result in serious injury or death.

    Always ensure that adequate PREPARATION for the recovery, to minimise the strain on either vehicle, has been undertaken i.e. Digging, Rock placement etc. If you do not understand how to use this equipment safely or are uncomfortable with your abilities in the use of recovery equipment, please complete a course that specialises in four wheel driving & 4WD vehicle recovery.
    HEAVY DUTY ROADSAFE TOYOTA FJ CRUISER RECOVERY TOW POINTS
    $145.00
  • Toyota FJ CRuiser Diff Drop Kit

    When lifting the Hilux 05-on, the Constant Velocity (CV) joints are put on an increased angle. This increased angle of the CV joint during
    operation can accelerate the wear on the joint, as well as putting additional stress on the CV boots leading to splitting and eventually premature
    failure of the CV. This wear is accelerated further if larger (wider) wheels and tyres are fitted.
    The Roadsafe Hilux Diff Drop Kit is supplied complete with spacers and fitting kit. The bolt on kit corrects the geometry on the front driveshaft
    and CV’s, lowering the front diff by approx. 25mm, thus reducing the angles the CV joints need to operate on, and avoiding the expensive
    replacements of CV’s and boots.

    Allows the bash plate to be refitted.
    Toyota FJ CRuiser Diff Drop Kit
    $159.00
  • Toyota FJ Cruiser 2010 on Standard Height Rear Polyair Air Bags



    Polyair Red Series bags are designed to fit inside the coil of a coil sprung vehicle to assist the spring in supporting whatever load is placed in the vehicle (within manufacturers recommended gross vehicle weight rating). They help in eliminating “bottoming out” and improve ride, handling and stability. The air adjustability allows you to tune the ride you want, whether you’re hauling, towing or riding light! Made with tough, long-lasting, moulded polyurethane.

    Features and benefits of the Polyair Red Series

    Add support to rear springs on many vehicles.
    Improves muscle car traction for drag racing.
    Improves ride and handling for full-size vans with front coils.
    Fits open coil springs, front or rear.
    Up to 450kg (1,000 lbs) of levelling capacity.*
    Air adjustable for the ride you want.
    Reduces roll, sway and “bottoming out.”
    Quick connecting easy-to-use engineered polymer air fittings.
    Tough moulded polyurethane construction.
    One year 20,000km limited warranty.
    Toyota FJ Cruiser 2010 on Standard Height Rear Polyair Air Bags
    $295.00
  • Toyota FJ Cruiser- 25mm = 37mm Front STRUT SPACERS

    Toyota FJ Cruiser- 25mm = 37mm Front COIL STRUT SPACERS
    Toyota FJ Cruiser- 25mm = 37mm Front STRUT SPACERS
    $150.00
  • Toyota FJ Cruiser 35mm=50mm FRONT STRUT SPACERS

    Toyota FJ Cruiser 35mm=50mm FRONT COIL STRUT SPACERS
    Toyota  FJ Cruiser  35mm=50mm FRONT STRUT SPACERS
    $180.00
  • TOYOTA FJ CRUISER 10-ON FRONT 2INCH-50MM BILSTEIN READY STRUTS

    TOYOTA FJ CRUISER 10-ON FRONT 2INCH-50MM BILSTEIN READY STRUTS

    A QUALITY SOLUTION THAT'S READY AND EASY TO FIT

    ARE YOU LOOKING TO RAISE UP, LEVEL OUT OR JUST REPLACE THE SUSPENSION IN THE FRONT OF YOUR COLORADO. READY STRUTS ARE AVAILABLE IN VARIOUS SPRING RATES AND HEIGHTS, MADE WITH HIGH QUALITY COMPONENT BRANDS – BILSTEIN STRUTS, KING SPRINGS, NEW UPPER MOUNTS WITH SUPERPRO BUSHES


    READY STRUT DELIVERS:

    ■ DIRECT REPLACEMENT - JUST BOLT IN FOR FRONT RAISED SUSPENSION SOLUTIONS
    ■ WE'VE DONE THE WORK - NO SPRING COMPRESSOR NEEDED
    ■ AVAILABLE IN BILSTEIN & RAW STRUTS - SPRING RATE OPTIONS - RIDE HEIGHT OPTIONS


    YOU RECEIVE

    ■ BILSTEIN 4X4 SHOCK ABSORBER (0-40MM SUSPENSION)
    ■ KING SPRINGS (OPTION AVAILABLE SEE BELOW)
    ■ NEW UPPER STRUT MOUNTS - INCLUDING SUPERPRO BUSHES
    TOYOTA FJ CRUISER 10-ON FRONT 2INCH-50MM BILSTEIN READY STRUTS
    $880.00
  • TOYOTA FJ CRUISER 10-ON 2INCH-50MM BILSTEIN / KINGS SUSPENSION LIFT KIT

    ARE YOU LOOKING TO RAISE THE HEIGHT OF YOUR TOYOTA FJ CRUISER. NEEDING TO UPGRADE FROM A STANDARD SUSPENSION SET UP WITH A 50MM RAISED SUSPENSION PACKAGE. IF SO THIS 50MM BILSTEIN LIFT KIT IS THE SOLUTION YOUR LOOKING FOR.

    FEATURES

    ■ FRONT BILSTEIN 4X4 SHOCK ABSORBERS PREASSEMBLED WITH RAISED KING SPRINGS
    ■ REAR BILSTEIN 4X4 SHOCK ABSORBERS
    ■ RAISED KING SPRINGS TO INCREASE THE HEIGHT IN THE FRONT
    ■ RAISED KING SPRINGS TO INCREASE THE HEIGHT IN THE REAR THIS 4X4 KIT

    THIS KIT DELIVERS A GREAT SOLUTION AT A FANTASIC PRICE, IT IS DESIGNED PRIMARILY FOR A CUSTOMER AFTER A SUSPENSION IMPROVEMENT/UPGRADE OVER ORIGINAL SUSPENSION SYSTEMS.

    IT WILL RAISE THE HEIGHT APPROX -

    - 50MM (CWGH) ALROUND
    TOYOTA FJ CRUISER 10-ON 2INCH-50MM BILSTEIN / KINGS SUSPENSION LIFT KIT
    $1,495.00
  • TOYOTA FJ CRUISER 4X4 2010-ON RAW / KING SUSPENSION LIFT KIT

    ARE YOU LOOKING TO RAISE THE HEIGHT OF YOUR TOYOTA FJ CRUISER, NEEDING TO UPGRADE FROM A STANDARD SUSPENSION SET UP WITH A 50MM RAISED SUSPENSION PACKAGE, IF SO THIS 50MM LIFT KIT IS THE SOLUTION YOUR LOOKING FOR.

    FEATURES

    ■ FRONT RAW 4X4 SHOCK ABSORBERS PREASSEMBLED WITH RAISED KING SPRINGS
    ■ REAR RAW 4X4 SHOCK ABSORBERS
    ■ RAISED KING SPRINGS FRONT
    ■ RAISED KING SPRINGS REAR



    THIS 4X4 KIT THIS KIT DELIVERS A GREAT SOLUTION AT A FANTASIC PRICE, IT IS DESIGNED PRIMARILY FOR A CUSTOMER AFTER A SUSPENSION IMPROVEMENT/UPGRADE OVER ORIGINAL SUSPENSION SYSTEMS.

    TOYOTA FJ CRUISER 4X4 2010-ON RAW / KING  SUSPENSION LIFT KIT
    $1,195.00
  • Toyota Prado 150series Blackhawk Upper Control Arms

    3 degrees increased caster built in

    Features & Benefits

    - Angled Ball joint Aperture - allows for better articulation of the ball stud
    - Repositioned Ball Joint Aperture - 3 degrees increased caster
    - OE Spec Ball Joint Aperture - takes standard factory or aftermarket ball joint
    - Revised Radius Bends (Internal) - increased suspension articulation
    - Revised Radius Bends (External) - allows fitment of larger tyres

    - OE Spec Bushing Aperture - takes standard factory or aftermarket bushings
    - supplied complete with high flex rubber bushings
    - Heavy Duty 32mm OD Tube (4mm wall) - increased strength over factory arm unit
    - Black E-Coating - maximum durability, rust prevention and discreet installation
    Toyota Prado 150series Blackhawk Upper Control Arms
    $750.00

Items 1 to 12 of 24 total

per page
Page:
  1. 1
  2. 2

Set Descending Direction