PadlockPay securely withVisaMastercard

Prado 120

For all your steering and suspension parts for your Toyota , from bushes , springs , shock absorbers ( Bilstein Koni Raw Sachs Kyb Formula ) , lift kits , airbags , Ball joints and Coil Over Kits

Items 1 to 12 of 63 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Set Descending Direction
  • Toyota Prado 120 Series Front 2Inch-50mm Raw Heavy Duty Rraised Ready Strut

    A QUALITY SOLUTION THAT'S READY AND EASY TO FIT

    ARE YOU LOOKING TO RAISE UP, LEVEL OUT OR JUST REPLACE THE SUSPENSION IN THE FRONT OF YOUR HILUX. READY STRUTS ARE AVAILABLE IN VARIOUS SPRING RATES AND HEIGHTS, MADE WITH HIGH QUALITY COMPONENT BRANDS – RAW PREDATOR STRUTS, KING SPRINGS, NEW UPPER MOUNTS WITH SUPERPRO BUSHES


    READY STRUT DELIVERS:

    ■ DIRECT REPLACEMENT - JUST BOLT IN FOR FRONT RAISED SUSPENSION SOLUTIONS
    ■ WE'VE DONE THE WORK - NO SPRING COMPRESSOR NEEDED
    ■ AVAILABLE IN BILSTEIN & RAW STRUTS - SPRING RATE OPTIONS - RIDE HEIGHT OPTIONS


    YOU RECEIVE

    ■ RAW PREDATOR 4X4 SHOCK ABSORBER (50MM SUSPENSION)
    ■ KING SPRINGS (OPTION AVAILABLE SEE BELOW)
    ■ NEW UPPER STRUT MOUNTS - INCLUDING SUPERPRO BUSHES

    FRONT SPRING RATE OPTIONS

    ■ STANDARD (COMFORT) - NOTHING OR LIGHT ALLOY BULLBAR
    ■ HEAVY DUTY - STEEL BULLBAR OR ALLOY BULLBAR & ACCESSORIES
    Toyota Prado 120 Series  Front 2Inch-50mm Raw  Heavy Duty Rraised  Ready Strut
    $730.00
  • Toyota FJ CRuiser Diff Drop Kit

    When lifting the Hilux 05-on, the Constant Velocity (CV) joints are put on an increased angle. This increased angle of the CV joint during
    operation can accelerate the wear on the joint, as well as putting additional stress on the CV boots leading to splitting and eventually premature
    failure of the CV. This wear is accelerated further if larger (wider) wheels and tyres are fitted.
    The Roadsafe Hilux Diff Drop Kit is supplied complete with spacers and fitting kit. The bolt on kit corrects the geometry on the front driveshaft
    and CV’s, lowering the front diff by approx. 25mm, thus reducing the angles the CV joints need to operate on, and avoiding the expensive
    replacements of CV’s and boots.

    Allows the bash plate to be refitted.
    Toyota FJ CRuiser Diff Drop Kit
    $159.00
  • Toyota Prado 120 series Polyair Airbag Kit Standard Height



    Polyair Red Series bags are designed to fit inside the coil of a coil sprung vehicle to assist the spring in supporting whatever load is placed in the vehicle (within manufacturers recommended gross vehicle weight rating). They help in eliminating “bottoming out” and improve ride, handling and stability. The air adjustability allows you to tune the ride you want, whether you’re hauling, towing or riding light! Made with tough, long-lasting, moulded polyurethane.

    Features and benefits of the Polyair Red Series

    Add support to rear springs on many vehicles.
    Improves muscle car traction for drag racing.
    Improves ride and handling for full-size vans with front coils.
    Fits open coil springs, front or rear.
    Up to 450kg (1,000 lbs) of levelling capacity.*
    Air adjustable for the ride you want.
    Reduces roll, sway and “bottoming out.”
    Quick connecting easy-to-use engineered polymer air fittings.
    Tough moulded polyurethane construction.
    One year 20,000km limited warranty.
    Toyota Prado 120 series Polyair Airbag Kit Standard Height
    $295.00
  • Toyota Prado 120 Series Front 2inch-50mm Raw Raised Ready Struts

    A QUALITY SOLUTION THAT'S READY AND EASY TO FIT

    ARE YOU LOOKING TO RAISE UP, LEVEL OUT OR JUST REPLACE THE SUSPENSION IN THE FRONT OF YOUR HILUX. READY STRUTS ARE AVAILABLE IN VARIOUS SPRING RATES AND HEIGHTS, MADE WITH HIGH QUALITY COMPONENT BRANDS – RAW PREDATOR STRUTS, KING SPRINGS, NEW UPPER MOUNTS WITH SUPERPRO BUSHES


    READY STRUT DELIVERS:

    ■ DIRECT REPLACEMENT - JUST BOLT IN FOR FRONT RAISED SUSPENSION SOLUTIONS
    ■ WE'VE DONE THE WORK - NO SPRING COMPRESSOR NEEDED
    ■ AVAILABLE IN BILSTEIN & RAW STRUTS - SPRING RATE OPTIONS - RIDE HEIGHT OPTIONS


    YOU RECEIVE

    ■ RAW PREDATOR 4X4 SHOCK ABSORBER (50MM SUSPENSION)
    ■ KING SPRINGS (OPTION AVAILABLE SEE BELOW)
    ■ NEW UPPER STRUT MOUNTS - INCLUDING SUPERPRO BUSHES

    FRONT SPRING RATE OPTIONS

    ■ STANDARD (COMFORT) - NOTHING OR LIGHT ALLOY BULLBAR
    ■ HEAVY DUTY - STEEL BULLBAR OR ALLOY BULLBAR & ACCESSORIES
    Toyota Prado 120 Series  Front 2inch-50mm Raw Raised  Ready Struts
    $730.00
  • Toyota Prado 120 series Front Strut Spacers 35mm

    Installation of Roadsafe Coil Strut Spacers is the ideal way of generating lift on vehicles with
    strut front ends. Coil Strut Spacers bolt to the top of the strut, and maintain full articulation
    of the front end. You can lift the front end to even out the nose dive appearance whilst still
    employing stock suspension.
    Toyota Prado 120 series Front Strut Spacers 35mm
    $180.00
  • TOYOTA PRADO 120 SERIES FRONT 2INCH-50MM RAW EXTRA HEIGHT READY STRUT

    A QUALITY SOLUTION THAT'S READY AND EASY TO FIT

    ARE YOU LOOKING TO RAISE UP, LEVEL OUT OR JUST REPLACE THE SUSPENSION IN THE FRONT OF YOUR HILUX. READY STRUTS ARE AVAILABLE IN VARIOUS SPRING RATES AND HEIGHTS, MADE WITH HIGH QUALITY COMPONENT BRANDS – RAW PREDATOR STRUTS, KING SPRINGS, NEW UPPER MOUNTS WITH SUPERPRO BUSHES


    READY STRUT DELIVERS:

    ■ DIRECT REPLACEMENT - JUST BOLT IN FOR FRONT RAISED SUSPENSION SOLUTIONS
    ■ WE'VE DONE THE WORK - NO SPRING COMPRESSOR NEEDED
    ■ AVAILABLE IN BILSTEIN & RAW STRUTS - SPRING RATE OPTIONS - RIDE HEIGHT OPTIONS


    YOU RECEIVE

    ■ RAW PREDATOR 4X4 SHOCK ABSORBER (50MM SUSPENSION)
    ■ KING SPRINGS (OPTION AVAILABLE SEE BELOW)
    ■ NEW UPPER STRUT MOUNTS - INCLUDING SUPERPRO BUSHES
    TOYOTA PRADO 120 SERIES  FRONT 2INCH-50MM RAW  EXTRA  HEIGHT READY STRUT
    $730.00
  • Toyota Prado 120 Series Front & Rear B6 OFFROAD Bilstein Shock Absorbers

    TOYOTA PRADO 120 SERIES FRONT AND REAR BILSTEIN SHOCK ABSORBERS

    Performance you can feel. If you expect more damping power from your shock absorber – even under loads – but don’t want to opt for an all-out race solution, the BILSTEIN B6 Sport is ideal.

    The product benefits at a glance:

    Increased power reserves and service life, even when pulling transporters and trailers or during frequent journeys with loads
    Optimum adhesion and enhanced lane change stability in both day-to-day and extreme situations
    Marked improvement in safety and performance without additional spring changes (standard springs can be used)
    BILSTEIN gas pressure technology
    BILSTEIN mono-tube/Upside-Down technology, made in Germany
    Road and track tested by BILSTEIN for fine tuning
    46mm piston, a winning formula with over 50 years of development
    Toyota Prado 120 Series Front & Rear B6 OFFROAD Bilstein Shock Absorbers
    $999.00
  • Toyota Prado 120 / 150 series Diff Drop Kit

    When lifting the Hilux 05-on, the Constant Velocity (CV) joints are put on an increased angle. This increased angle of the CV joint during
    operation can accelerate the wear on the joint, as well as putting additional stress on the CV boots leading to splitting and eventually premature failure of the CV. This wear is accelerated further if larger (wider) wheels and tyres are fitted.The Roadsafe Hilux Diff Drop Kit is supplied complete with spacers and fitting kit. The bolt on kit corrects the geometry on the front drive shaft and CV’s, lowering the front diff by approx. 25mm, thus reducing the angles the CV joints need to operate on, and avoiding the expensive replacements of CV’s and boots.

    Allows the bash plate to be refitted.
    Toyota Prado 120 / 150 series Diff Drop Kit
    $159.00
  • Toyota Prado 120 Series 2inch-50MM Bilstein Suspension Lift Kit

    TOYOTA PRADO 120 SERIES 2INCH-50MM BILSTEIN SUSPENSION LIFT KIT

    TOYOTA PRADO 4X4 SUSPENSION LIFT KIT


    ARE YOU LOOKING TO RAISE THE HEIGHT OF YOUR TOYOTA PRADO 120/150 SERIES 2003-ON. NEEDING TO UPGRADE FROM STANDARD SUSPENSION TO A LIFTED SUSPENSION PACKAGE OF 50MM WHILE STAYING WITHIN GOVERNMENT REGULATIONS. IF SO THIS 50MM BILSTEIN PERFORMANCE LIFT KIT

    FEATURES

    ■ FRONT BILSTEIN 4X4 SHOCK ABSORBERS PREASSEMBLED WITH RAISED KING SPRINGS INCLUDING TOP CAPS (NO SPRING COMPRESSOR NEEDED)
    ■ REAR BILSTEIN 4X4 SHOCK ABSORBERS
    ■ KING SPRINGS TO INCREASE THE HEIGHT IN THE REAR
    Toyota Prado 120 Series 2inch-50MM Bilstein Suspension Lift Kit
    $1,499.00
  • Toyota Prado 120 Series Front Koni Shock Absorbers

    82series


    KONI is the premier manufacturer of adjustable shock absorbers in the world. KONI shocks are made from the highest quality raw materials and machined to the tightest tolerances.

    KONI shock absorbers have been a respected product in the Australian 4WD market for more than 20 years. This reputation was built on the existing range of KONI shocks, a choice for motoring enthusiasts in Australia since 1970! With an ever increasing demand for high performance products and wanting to be able to meet the many different requirements of 4WD vehicles, KONI and Toperformance have introduced two additional dampers for 4WD use.

    KONI Heavy Track and RAID are specifically designed to improve vehicle damping characteristics both on-road and off-road. Specifically designed for SUV, 4WD, and Light Truck applications, these shock absorbers have been chosen as the damper of choice for support vehicles on the Dakar Rally, the team at Beadell Tours as they travel the Australian desert, and even selected as the preferred damper for the Top Gear North Pole Special.

    All KONI 4WD shock absorbers have an adjustable rebound function. This adjustment facility is primarily used for the restoration of “lost” damping after tens and thousands of kilometres. The adjustment also adds provides and extra resource as an excellent “tuning” tool to compliment vehicles with heavier springs and carrying higher loads.
    Toyota Prado 120 Series Front Koni Shock Absorbers
    $630.00
  • TOYOTA PRADO 120 series RAISED REAR BILSTEIN SHOCK ABSORBER

    Bilstein B6 Offroad

    For off-road, 4 Wheel Drive performance.

    For off-road vehicles, we offer a version of the BILSTEIN B6 that is adapted to Australian 4 Wheel Drive requirements. The precise Bilstein damper settings reduce uncontrolled movements caused by the high 4 Wheel drive structure, they also improve the suspension’s load carrying capacity, as well as guaranteeing more vehicle control and, therefore, safer handling and better traction.

    The product benefits at a glance:

    Greater performance reserves and service life, even when towing or in off-road applications
    Optimum adhesion and enhanced lane change stability in both day-to-day and extreme situations
    Marked improvement in safety and performance without additional spring changes (standard springs can be used)
    BILSTEIN gas pressure technology
    BILSTEIN mono-tube/Upside-Down technology, made in Germany
    Road and track tested by BILSTEIN for fine tuning
    46mm piston, a winning formula with over 50 years of development
    TOYOTA PRADO 120 series RAISED REAR BILSTEIN SHOCK ABSORBER
    $440.00
  • Toyota Prado 120 Series Airbag Man Coilrite Kit - CR5035

    ARE YOU CARRYING HEAVY LOADS, LOOKING FOR EXTRA SUPPORT WITHOUT MAKING YOUR RIDE STIFF AND HARSH WHEN NO LOAD IS ON THE VEHICLE, IF SO THEN THIS AIRBAGMAN RIDE RITE KIT COULD BE THE SOLUTION YOUR LOOKING FOR.

    FEATURES

    • FLEXIBILITY OF ADJUSTABLE HEIGHT TO LOAD LEVEL CONTROL ENSURING THE CORRECT DRIVING POSTION NO MATTER THE LOAD
    • NO DRILLING REQUIREMENT MAKING IT EASIER TO FIT.
    • BETTER TYRE WEAR
    • EVEN BRAKE WEAR
    • IMPROVED STEERING AND HANDLING CONTROL

    12 MONTH / 20000KLM WARRANTY
    Toyota Prado 120 Series Airbag Man Coilrite Kit - CR5035
    $295.00

Items 1 to 12 of 63 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Set Descending Direction